|
A compact, industrial strength, BREAK OUT BOX used to monitor and redirect RS-232-C circuits.  |
Tests both DB9 and DB25 interfaces, higher speeds and lower voltages. It has a pulse trap and voltage indication. It combines the advantages of a line and battery powered RS232 breakout box.  |
multi protocol converter (2 line) for RS232 type testers (RS422, RS485, RS530, V.35 to RS-232)  |
|
Communications tester Parallel Interface breakout box  |
RS232LM inexpensive line
status monitor |
 |
Cost effective RS530 LED Based Line Monitor |
Click to go to
BENEDICT
COMPUTER Homepage of
hand held RS232 / RS422
MONITORS
& Test Equipment
(Click on image to get full page photo)
Industrial
Strength 102 LED BOB with Current Loop Testing
Interface Connectors
One female and one male 25 pin Sub-D connector
Signal Status Display
Mark, Space, Clocking, None indication on all 25
pins
on both sides of the breakout switches.
Access Sockets
Sockets are located on both sides of the breakout
switches
allowing direct access to both interfaces.
Jumper Cables / Patching
A sturdy set of jumper cables with high quality gold
plated plugs is provided to allow cross patches of interface lines.
Included
are six two-pin jumpers plus two four-pin jumpers.
Ground Potential Differences Test Circuit
The different ground potentials of the two
interfaced
devices can cause problems with signal interpretation. The Circuit
testing
this difference makes use of G. P. D. monitor connected to the left
side
of switch #7.
Power/Test Voltage Sources
The basic function of the BOB100 do not require
battery
power. The tester can use one 9 volt battery for the purpose of
generating
+ or + voltage for testing.
Physical (Hand Sized)
7.4 x 3.4 x .7 inches, 8.9 ounces.
Current Loop Test Circuit
The Current loop test circuit can be used to measure
4, 10, 20, and 60 mA circuits. The LED illuminates at 80% of the stated
current.
Maximum current is 3 times stated with an upper limit of 80 mA.
Packaging
The BOB100 is supplied with a small leatherette
case,
jumpers, manual, battery connector, and 11 inch cable.
Click here to receive more information