2) The DLM200 will tell you whether to hit "W" or "A" to autoconfigure. Hit which ever key it says. The DLM200 will now say waiting for Data.
3) Now on the terminal, or terminal emulation program, hit alternate "a" and "c".
Within 20 characters the DLM200 will tell you speed and bit configuration
and begin capturing data. If you did not see the speed, simply hit the MENU key
on the DLM200 and you will see the correct settings.
Exercising Serial Terminals by transmitting data
1) Using a NULL MODEM connector (or use the included break out box to swap pins 2 and 3) between the DLM200 and the terminal, after you have set your speed correctly (above), just hit "O". This will put you into the output screen with all defaults set. Now just hit the START/STOP button and the DLM200 will attach its transmitter to pin 2, the null modem will swap the
output to pin 3 and the data will go to the terminal and you will see
the alphabet on the screen.
Click to go to BENEDICT
COMPUTER Homepage of
hand held RS232 / RS422 MONITORS
& Test Equipment